Refinishing Hardwood Floors – Sanding

Golvslipning Stockholm

Refinishing a hardwood floor is an easy approach to add beauty and value to any home. It could also be a real ego boost for the do it yourselfer. Undertaking it oneself will save you money for those who follow these uncomplicated steps. Get a lot more data about Golvslipning Stockholm

One of the most vital aspect to consider when refinishing is actually a hardwood floor is cleanliness. You need to make sure the floor is free from any debris. Debris can get caught in the sander and damage the floor. Little jagged stones would be the most damaging. At times it isn’t probable to determine the damage until following you apply your finish coats, and after that it’s too late.

The baseboards are also another issue it’s essential to take into consideration. In case you are confident together with your skills, you can gently take away them having a smaller flat-bar along with a hammer. Take your time. The idea is to take away and replace, not remove and after that drive to the hardware store mainly because you broke the boards. You are able to leave the baseboards in spot if it isn’t practical to remove them. If you decide on to leave the baseboards, I advocate that you just safeguard them with painters tape. The power sander will damage them should you will not be careful.

When the floor is clean, and also the baseboards happen to be removed or protected sufficiently, you are able to start to sand. I propose renting an orbital sander using a rectangular face. (Be cautious when transporting it to and from your home and be sure to have a person help when lifting the sander.) Begin with 80 grit sand paper. Guide the sander smoothly over the floor. Be sure you are sanding parallel with all the joints in the floor. Try not to sand perpendicular towards the joints, as this kind of sanding can damage the wood and cause the finish to look significantly less than perfect. The number of passes it requires to remove the old finish will differ from floor to floor. Be deliberate. Remove each of the old finish just before you move to a smaller girt sand paper.

Now that you are performed sanding together with the 80 grit sand paper, you will want to sweep or vacuum the floor. This removes any big wood particles or debris that might have been dislodged. When cleaned, sand the floor in precisely the same fashion using 120 grit sand paper. You might notice the 120 grit sand paper sands very efficiently. This can be for the reason that you will be no longer sanding by way of the old finish and the sand paper is straight on the face on the wood. Make an effort to be smooth and fluid as you move the sander. In the event you pause or stop, you may over sand and produce low spots within the floor.

You might know when the sanding is full by the look and really feel from the floor. Visually you will not see any shinny or glossy locations. The floor may have a smooth and dry really feel to it. Take you time to crawl around and closely inspect the floor. For those who uncover any areas that do not meet your standards, cautiously sand them again. As you sand more than the imperfections, make sure that you just do not hold the sander in one place for any prolonged period of time. Alternatively, make passes over the location needing to be sanded; short ones initially, followed by progressively longer ones. This technique is called feathering and can help avoid over sanding your floor in any one region.

Soon after your final inspection with the floor is comprehensive, you’ll wish to clean once more. Deliberately vacuum or sweep up all of the debris. Then, using a slightly damp cotton towel, wipe over the complete floor surface. Whenever you are wiping, retain the towel in one orientation against the floor. Do not choose it up. The objective is usually to capture any tiny debris left behind on the front face of the towel. You can notice that the floor wicks several of the water out from the towel. That is typical and can not affect your final finish provided that you enable it to dry.

In conclusion, refinishing a hardwood floor does not have to be challenging. Recall to clean the floor before you commence to sand. Clean the floor whenever you adjust the girt size of the sand paper you are using. When full, you will have a smooth floor prepared to accept its initial coat of finish.

Comments are closed